1. Access: One-component silicone glue can be used immediately, and it can be easily shot out of the bottle with a glue gun.
2. Bonding:
A. Completely wipe the metal and plastic surfaces to remove oil stains. First, rinse all surfaces of the plastic with acetone, and polish the rubber surface with sandpaper, then wipe with acetone.
B. Spread the silicone glue evenly on the surface of the ready object. If you are bonding two surfaces together, you can locate one side first, and then squeeze the other side with enough force to squeeze out the air, but Be careful not to squeeze the glass glue.
C. Put the bonded device at room temperature until the glue is cured.
3. Sealing: When silicone glue is used for sealing, follow the same steps as mentioned above, squeeze the glue into the joint surface or gap to make the glass glue fully contact the surface.
4. Cleaning: The glass glue can be wiped off with a cloth or paper towel before it is cured. After it has been cured, it must be scraped off with a spatula or scrubbed with solvents such as xylene and acetone.